5G NR Outdoor Router
NR7102
System specifications
IP networking
Supports IPv4/IPv6 dual stack (NDP IPv6)
DHCP server
Supports ICMP
Virtual Private Network (VPN) pass-through
Multiple APNs with VLAN mapping
NAT
Supports NAT/NAPT
Supports DMZ
Supports port forwarding
Supports port triggering
Supports ALG
Supports NAT enable/disable
Routing
Supports router or bridge mode
Supports dynamic DNS for first APN
Supports remote management under bridge mode
Static/dynamic routing settings, RIP 1 & 2
IP firewall
Firewall can be enabled or disabled via GUI
DoS attack prevention
Supports SPI
Application-level firewall
Filters LAN MAC address
Filters LAN IP address
Filters URLs
Management
Supports local/remote device management and firmware upgrade via web GUI
APN management
PIN/PUK management
Network selection
Network preference
Operating frequency band selection
Supports UPnP IGD
Supports Zyxel Air app (iOS and Android) for easy installation and local management only
Hardware specifications
5G NR interface
3GPP Release 15 standard-compliant
Supports both NSA and SA modes
Supports frequencies:
n1/n3/n5/n7/n8/n20/n28/n38/n40/n41/n77/n78
DL 4×4 MIMO:
n1/n3/n7/n38/n40/n41/n77/n78
UL 2×2 MIMO:
n41/n77/n78
Data rates*:
5G NSA: DL 5.0Gbps*; UL 650Mbps*
5G SA: DL 4.2Gbps*; UL 900Mbps*
Supports DL modulation QPSK, 16-QAM, 64-QAM and 256-QAM
Supports UL modulation QPSK, 16-QAM, 64-QAM and 256-QAM
Output power:
Class 2 (26 dBm) for n41/n77/n78
Class 3 (23 dBm) for n1/n3/n5/n7/n8/n20/n38/n40
4G LTE interface
3GPP UE Category 20 standard-compliant
Supports frequencies:
LTE-FDD: B1/B3/B5/B7/B8/B20/B28
LTE-TDD: B38/B40/B41/B42/B43
DL 4×4 MIMO:
B1/B3/B7/B38/B40/B41/B42/B43
Peak data rates:
DL 2.0 Gbps; UL 200 Mbps
Supports DL modulation QPSK, 16-QAM, 64-QAM and 256-QAM
Supports UL modulation QPSK, 16-QAM, 64-QAM and 256-QAM
Output power class 3 (23 dBm) for FDD/TDD bands
5G/4G antennas
Four embedded directional antennas:
Ultra-high band: up to 9 dBi peak gain
High band and middle band: up to 8 dBi peak gain
Low band: up to 4 dBi peak gain
GPS/GNSS interface
One Embedded GPS/GNSS antenna
Supports GPS/Galileo/QZSS (L1/E1)
Supports GLONASS/BeiDou
Supports Positioning Information
WiFi AP features (ODU)
802.11 n/g/b, 2.4 GHz, N300**
Hidden SSID
Two embedded antennas
Hardware interface
One 2.5GbE RJ-45 PoE LAN port
LED indicators
Power/internet/WiFi status
Signal strength
One 3FF format Micro SIM card slot
One reboot/reset to default button
Power consumption
Standard 802.3af/at 2.5G Power over Ethernet
Power consumption at PoE:
Physical specifications
Item
Dimensions (LxWxH):
255 x 256 x 58 mm (10.04” x 10.08” x 2.28”)
Weight:
1112 g (2.45 lb.)
Packing
Dimensions (WxDxH):
280 x 360 x 108 mm (11.02” x 14.17” x 4.25”)
Weight:
2498 g (5.51 lb.)
Environmental specifications
Operating environment
Temperature:
-40°C to 60°C (-40°F to 140°F)
Humidity:
5% to 95% RH (non-condensing)
Storage environment
Temperature:
-40°C to 65°C (-40°F to 149°F)
Humidity:
5% to 95% RH (non-condensing)
Ingress protection rating
IP68
Lightning protection
K.21 enhanced mode, 6 KV
Wind load testing
GR 487 issue 4 (2013) standard complaint
Beaufort scale level 16 wind force wind speed 53.6 m/sec (~193km/h)
Certification
CE
Package contents
Power over Ethernet PoE injector
1.8M Ethernet cable 8P8C
PG19 thread (cable gland)
Quick Start Guide
Warranty card
DoC and safety warning
Wall/pole mounting kit
- *1. The maximum data rate is a theoretical value. The actual data rate depends on the operator.
- *2. WiFi interface is used for local management purposes only.
- *3. All specifications are subject to change without notice.